A Servo company - serving McKinney, TX

Before & After Gallery - Servo Garage Doors McKinney

Every visit starts with

Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included

Your new garage door for as low as $59/month*on approved credit; ask for current terms

You get a price before we start. It does not change when the truck arrives.

Styles & brands we work with

Raised-panel steel
Raised-panel steel
Carriage house
Carriage house
Modern flush
Modern flush
Full-view glass
Full-view glass
LiftMaster openers
LiftMaster openers
Chamberlain openers
Chamberlain openers

Before & after – our own jobs

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Garage Door Before & After in McKinney, TX

Photos tell the truth faster than adjectives ever could. That’s why we document every job with a photo record tracing back to the founding rule Servo was built on in 2015: the customer sees the failed part before anyone quotes a replacement. The transformations below represent the kind of work we do across McKinney, from Stonebridge Ranch to Craig Ranch. Same diagnostic honesty, same written price before any work starts, same documented result when we leave.

Call (469) 815-7610

Recent Transformations

Torsion Spring Failure in Stonebridge Ranch

Before: broken torsion spring on a double garage door in Stonebridge Ranch, McKinney TX
Before: torsion spring with a clean break at the coil, 0.225-inch wire diameter, left side.
After: new torsion springs installed on a garage door in McKinney, balanced and tested
After: replacement springs matched to the door’s weight, balance-tested, and documented.

The torsion spring measured at 0.225-inch wire diameter and showed a clean break at the coil, the kind that happens around the 10,000-cycle mark. We pulled the old spring, verified the door weight, and installed a matched pair of galvanized springs rather than a single replacement. The door now lifts with one hand on the emergency release and holds position at mid-travel, which is exactly what a balanced door should do.

Off-Track Door After a Hard Close in Craig Ranch

Before: garage door off its track with bent roller in Craig Ranch, McKinney
Before: door pulled off the left track, three rollers dislodged, lower panel bowed outward.
After: garage door re-seated on track with new rollers in McKinney TX
After: door re-seated, new nylon-bearing rollers installed, track realigned and lubricated.

A bent roller popped out of the track when the door came down on a rake handle, and the homeowner kept hitting the opener. That forced the lower panel outward and pulled two more rollers out behind it. We removed the tension safely, re-seated the panels, replaced all four rollers on the left side with nylon-bearing units, and trued the track with a level. The door runs quiet now and clears the lintel by a full inch on both sides.

Opener Logic Board Replacement in Trinity Falls

Before: garage door opener with failed logic board, wall button unresponsive in McKinney
Before: opener motor buzzing but not engaging, wall button dark, logic board showing a blown capacitor.
After: new logic board installed in Chamberlian garage door opener, McKinney TX
After: replacement logic board installed, opener reprogrammed and safety sensors verified.

The opener was a Chamberlain PD612 with a logic board that had a blown capacitor, visible on the bench before we ever quoted the replacement. We installed a factory board, reprogrammed the travel limits and force settings, and verified the photo-eye sensors reversed the door correctly. The wall button lights up now, and the remote range improved by about fifteen feet because the new board’s receiver isn’t fighting a failing capacitor.

Wood Door Replacement to Insulated Steel in Eldorado Heights

Before: weathered wood garage door with rotted bottom panel in Eldorado Heights, McKinney
Before: cedar door with rotted bottom rail, three cracked panels, and single-pane glazing losing heat.
After: new insulated steel garage door with windows in McKinney TX
After: new double-layer steel door with polyurethane insulation and insulated glazing, painted to match trim.

The original cedar door had a rotted bottom rail that had been patched twice and was still wicking moisture into the lower panel. We measured the opening, ordered a double-layer steel door with a 10.2 R-value, and hung it on new track with a fresh seal along the sill. The owner’s utility bill dropped $18 a month through that McKinney winter, and the new door doesn’t bow when the afternoon sun hits the west-facing elevation.

Broken Cable with a Side of DIY in Allen

Before: frayed and snapped garage door cable, door sagging at an angle in Allen TX
Before: right-side cable snapped three feet from the drum, door hanging at a 7-degree angle.
After: new cable assembly installed on garage door, door level in McKinney TX
After: new cables on both sides, drums re-wrapped, door level and cycling smoothly.

We get at least one of these a month: someone tried to adjust spring tension with a crescent wrench and ended up with a cable off the drum. In this case the right cable snapped three feet from the drum and the door was hanging at a 7-degree angle, still connected to the opener. We released the tension safely, replaced both cables as a set, and re-wrapped the drums with equal turns. We also photographed the failed cable before quoting the replacement, per Clause 4, and the customer kept the photo.

Commercial Dock Door Service in McKinney’s Industrial District

Before: warehouse dock door with broken spring and bent track section in McKinney
Before: 14-foot commercial door with a broken spring and a bent section of vertical track from a forklift strike.
After: commercial dock door repaired and operational in McKinney TX industrial district
After: new spring assembly installed, track section replaced, door cycling under load.

A forklift clipped the right vertical track and the door kept binding against it until the spring gave out under the strain. We replaced the bent track section, installed a heavier spring assembly rated for the door’s 14-foot drop, and set the cable tension on both sides to within an eighth of an inch. The door now cycles under load eight to ten times a day without drifting, and the facility manager has our number saved.

Want Results Like These?

Technician using a level to align a garage door track
Want Results Like These?

Every job above started with a phone call and ended with a written price before any work began, plus a photo record of what we found and what we fixed. If your garage door in McKinney needs work, call Servo Garage Doors McKinney at (469) 815-7610. We’ll tell you the price range, and we’ll put it in writing before the first tool comes off the truck.

Written by Marcus Deller, Owner at Servo Garage Doors McKinney, serving McKinney since 2015.

Need Garage Door help in McKinney? Licensed & insured · 60-minute response · free estimates
Call (469) 815-7610
Local Service Coverage

Request a Free Estimate in McKinney

Tell us what you need - Servo Garage Doors McKinney responds fast. No obligation.

When you send us your details, you accept our Privacy Policy and consent to being contacted by call, text, or email concerning your request, including by the partner businesses that may perform the service.

Call Now - 24/7 Dispatch